|
Farmall & IHC Tractors Discussion Board |
Re: Cub differences
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by p on April 02, 2000 at 23:03:57 from (166.90.85.80):
In Reply to: Cub differences posted by John H. on April 02, 2000 at 16:41:42:
where do I start?,....the serial number and model number are on the front drivers side of the tractor on a metal tag near where the steering arm connects to the steering box ( can be seen in pictures in enclosed link),just behind the nearby water pipe that connect the lower bolster and the engine block look where the block turns outward 90 degrees to attach to the front end(where the bolts are). In this corner they tend to crack, this is not tragic but it should be welded to hold back the oil and the pictured brace made to support it and should be watched out for since it is relatively common.)also a way to lower the price) The low boy is basically the same tractor with rear drop housings rotated forward and shorter spindles in front. the rear housing change and lower stance makes the implements different( I don't know if an adapter can be made or is available ). The 184 and such I am know are different but I am not that familiar. as for the international and Farmall differences I am also not entirely sure. I think they are the same with minor differences like a stronger frontend. I recommend the Cub highly as a mower. I have the Woods model 42C and it cuts like a golf course mower. and will also cut tall grass, best of both worlds. I also have seen 3 pt. kits available but the pto spins at engine rpms and the opposite direction so a gear box adapter may be needed.( I have heard that this has been done to force only small manageable item designed for the cub to be used....hope this helps, let me know if I can help more, or explain better.....p
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
