old tired said: (quoted from post at 07:28:01 01/09/09) howdy spiffy1
Thanks for the help. On puller IH dealer thinks they have one that will work.Sounds like 1# hammer works for you. Use it the best one made.
I have seals ordered from fordson house and Darrell at Alderson tractor is watching for gas manifold. All nice people.
Thanks again
Gas manifold, with exhaust through the hood? One of those should turn up quick enough.
However if you have two-bolt-side mount carburator (probably not, since you specified "gas manifold") and want to be creative [I've never seen this done, but assume some farmers must have tried it being envious of their neighbor with upgrades from a P300, but too frugal to buy the parts]:
I know of someone with a combination manifold that is nasty on the bottom kerosene exhuast route, but looks to be good yet on the intake and gas side.
Someone with a pre-heat oven and good at welding cast could cap the exhaust routing for the kero. If you're coming through the top [rather than in front of the air cleaner], it would be really fun to see an adaptor & exhaust pipe bolted in place of the to selector plate and the gas exhaust route capped too. That noted, unless you're doing the work yourself - this would add up $$$ far quicker than the gas manifold!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
