I am curious myself. Like I have said before the CHN dealer I use has some guys that have little drive or desire to help when it comes to older tractor parts. They would just soon send me to the sales counter for a new tractor. Even though I had the CNH system and my TC-88 Parts manual I kinda shot in the dark on the pump situation.
I bought the pump online from Marshalls Tractor in KY. It came branded a Hy-Capacity, checked on them, good parts, good prices. I just pulled out the TC-88 and it DOES NOT show the 17 gpm for the F504, only the I504. BUT it does show three different gears for the F504: 14T 501-2469, 15T 2470-5159 (I have this one), 17T 5160-up... I was going to put a new gear on it for grins until I priced one, $180! I was also going to replace the suction tube 395334R91 but it was about $50. I never saw anything on the 21T gear...
For the I504 the 17 gpm pump is listed. It also has three different gears. 14T 501-511, 15T 512-1329, 17T 1330-up... It also says when replacing 373964R92 or 374483R92 also use 395335R91 suction tube.
Interesting enough it also list a tandem filter assembly, less elements for the I504 number 382854R91 and also, package 388085R91, valve 386121R92, cover 388083R1, and six screws 179847 for S/N 501-12265. I had no luck on these items... Hence the Allied Precision Extension, probably much cheaper and better to boot!
This is probably a lot of useless info and obselete numbers. Good luck and if I can help the EMAIL is open as well as the forum.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
