Pete, you're too kind. You may not know of it, but Mac Davis had a recording back in the 70s of a song, "Lord, it's hard to be humble, when you're perfect in every way." Maybe try Googling for the lyrics -- it was done very much tongue-in-cheek.
I say that by way of saying I'm known to screw it up every now and then, too, and when it gets pointed out to me (however gently or roughly that may be done), I take the attitude I've learned something adn try to make sure whoever asked the question sees the correction.
This board is meant for everybody to be able to contribute and a lot of folks of every level of experience and ability do. And apart from basic procedures on things, there's always little tricks to be picked up her and there that someone figured out or learned along the line. For the most part it's all good advice; if it's dead wrong, someone else will chime in to set things straight.
But, again, kudos to you on your contributions to this thread. They'd be a big help to anybody getting into that job.
By way of sharing, the link below is to a few of the pages left from a website I sued to keep running, and will get going again here one day. Has some pics from my BN project mostly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
