No , you do not locktite the injector in . Some people use it on the sleeve or cup tube what ever ya want to call it to seal it to the head. IF the head is clean and the installation is done correctly then nothing is needed , as this is my thinking on this just where does the tip of that tube cup sleeve go but wright into the combustion chamber area and that area is going to get really HOT and i really do not think that the loctite is going to stand up to those temps. One of my long time friend ran a machine shop and in all the time that i knew him i have never seen him put anything on a tube . Clean the area up with a injector well brush make it shine and install the tube with the proper driver and it is done . Now where can i get a driver???? Maybe now i said maybe you can barrow rent or ya may have to buy one . It will not be cheap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.