Len: I have the 1968 buyers guide, and the frame is slightly different on mounted and trailer model. The trailer tongue goes from tractor to back of cultivator, with braces going from tongue, diagnol out about 4' then parallel with tongue attaching to all tool bars to the back, One on each side. The mounted models have pull frame up middle and diagnol pull frame to all tool bars from hitch linkage. The one they are showing is 3 point, I expect those would be closer to parallel on the fast hitch model.
The trailing wing has much heavier frame all over. Center section is quite massive, and is only 11' wide. I had a 10' trailer and 24' trailing wing. I can't remember the wheel sizes. This buyers guide doesn't say. Somewhere in my treasures I have the shank set up manual for each, but doubt if that gives tire and wheel sizes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
