Posted by Michael hicks on February 23, 2009 at 13:27:49 from (142.165.20.132):
Hello all. I am having a bear of a time putting the hydraulic couplers back together on my 1086. Took them apart to repair the leak. I cannot get the piston assembly to fit/slide past those flat o-rings. Anyone who has worked on them will know what I am talking about. The flat o-ring fits over a regular o-ring. They both fit in a groove in the coupler body.
There must be a trick to this. I have already wrecked a couple of the flat o-rings and want some ideas before I go at it again.
Any ideas greatly appreciated. These are the original, IH type couplers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.