Posted by davset on March 02, 2009 at 02:36:40 from (66.190.144.235):
I recently bought a A151 for my Farmall A. The hand lever that attaches to the front of the final drives has a spring with an angle-iron bracket. The gentleman who sold me the plow said it attaches to the left-side final drive with the spring in a vertical position. I must be missing something because I can"t seem to get it there. Also, I previously purchased another lever assembly (in a package deal with a set of cultivators), but it has a short "L" bracket on the spring. Where would it attach - to the clutch housing under the cultivator rockshaft bearings? Which one - the short or long bracket - is correct, or is one a later modification of the other? Thanks for your help. (pictures would be a plus.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.