When I painted the cast frame, radiator and engine on my 10-20 I used Dupont Centari without hardener and brushed it on just the cast parts. It looked super nice! I did try it on the sheet metal, but I have to say there is a trick to that and I didn't work with it long enough to figure it out so I would spray sheetmetal, but the cast parts MAM o MAN! I have brushpainted with lacquer years ago and it came out good as a spray job. Had to use slow dry thinner and a very good brush. Cheap brush will not cut it at all and will ruin the job. One brush for primer, and another for color. Spread paint one direction and then go back and do it again diagonally then back the same direction. Have to be fast or it will start to ball up. Then when all is done and dry good for a few days, wet sand with sanding block and very fine paper like 800- 1000 grit and rub it out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Collection of a Lifetime - by Sherry Schaefer. The larest gathering of orphan tractors ever assembled by one collector will be auctioned off on May 15 in Rock Island, IL. Ed Spiess was a well known tractor buff who spent most of his time dreaming of rare and unknown tractors. His background as an agricultural engineer sparked his interest in the unique attributes of the models built from 1939-1959.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
