Posted by Eric NW Iowa on April 16, 2009 at 16:20:04 from (207.177.84.162):
Last night we took the 656 gas out for a little workout with the disk (15' tandem). After a stop for supper and refueling, we headed out to finish the 4 acres across the creek. After warming up, I noticed a spark drift away from the tractor... assumed it was out of the exhaust stack. Couple seconds later - saw another. I started noticing a spark floating away from the fan/alternator region every few seconds. Assuming I had finally gotten the engine good and hot after a year or so of light loader duty - I assumed it was just oil and debris from the block or exhaust manifold. A few passes later, the Gen light came on. Not wanting a dead tractor in the middle of the field, I drove back to the yard, unhooked the disk, and put the tractor in the shed where the lights and tools are.
I did not do any troubleshooting beyond this as I didn't have my owners manual available. I haven't been back to work on it, but got a few photos before heading to work today.
Here are my questions - I invite your feedback!
1.) Since the Gen light came on, do you suspect the sparks came from the Alternator/Generator or another source?
2.)Is the Alternator/Generator in the Photo a factory part? Please identify.
3.)What troubleshooting steps would you take from this point on? (there is a Westendorf WL30 loader on the tractor if that would cause you to instruct me differently for engine access)
It's been a few years since I posted to this site... You've been very good to me in the past. I thank you in advance for any help you can give.
Eric
I tried to attach a image location, but haven't been registered long enough yet
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.