Posted by Harold hubbard on May 03, 2009 at 07:17:46 from (207.235.125.47):
I have been plowing with a Farmall C with a side hill (two-way) single bottom plow for about three forevers. It has been many years since I have plowed much more than a garden or two. Now I am beginning to renovate some hay ground that has been neglected for too many years. I guess I had forgotten, or maybe when I was 19 I didn't care, how long it takes to plow one furrow at a time. How about 13 hours to do three acres? Besides that, I think there is more welding rod in the bottoms than there was steel originally.
Now I do have a Farmall 560D, which I think should easily handle three bottoms in my soils. Will I hate myself if I try to use a three point plow with an adapter on my fast hitch, or should I wait until I can find a fast hitch plow? What am I likely to find for a fast hitch, and will there be parts available? Are they solid or trip bottoms or hopefully spring resets. I have watched my neighbors dealing with trip bottoms on some of this rocky ground and it looks like a lot of fun. Plow ten feet, back up and reset. I am probably dreaming if I think I can find a rollover, but that would be ideal. Most of my ground is sloped enough that I will still have to plow most of it one way, turning the furrow uphill, and dead head back across to start over again. Two bottoms wouldn't be much faster that way than one, so I need at least three.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.