Posted by ScottyHOMEy on May 06, 2009 at 07:13:46 from (70.105.224.169):
In Reply to: Pully posted by Ron Corkum on May 06, 2009 at 05:58:02:
There were all different-size pulleys available for an A, from 6-1/2" diameter, going by inches all the way up to 10-1/2", with 8-1/2" being what you got if you didn't specify another size. That's what the Operator's Manual says. Looking in the Parts Catalog, though, all that are to be found are 8-1/2" and 10-1/2", no mention of the others.
For the SuperC, Operator's Manual lists only a standard 8-1/2" and an optional 7-1/2", but Parts Catalog lists those and a third one, 6-1/2" that is also slightly narrower.
Center splines were the same and so pulleys were interchangeable regardless of A/B/C model.
So maybe you've got a larger one and could find a smaller one. What bracket is interfering? Is this part of a Fast-Hitch, or has someone fitted a three-point hitch of some sort?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
