|
Farmall & IHC Tractors Discussion Board |
Re: The problems with my 48 cub
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Chris on April 10, 2000 at 19:12:54 from (64.24.59.202):
In Reply to: The problems with my 48 cub posted by Mike Shoemaker on April 10, 2000 at 16:24:07:
All the suggestions given so far are pretty much everything that can go wrong. One thing to check is the main carburator jet. It's the hex-head nut on the side of the carb. There is a tiny pin-sized hole at the end. Mine was plugged up with old gas. If need to clean it, used compressed air or maybe some fishing line--anything that WILL NOT scratch up the metering holes. Like previously mentioned, with the fuel bowl valve turned on (undeneath the tank) pull the main jet and fuel should flow out freely. If not, work your way up the fuel line through the various fittings and filters and find the culprit (if it exists.) Good luck, Chris
Follow Ups:
Home
| Forums
Today's Featured Article -
The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
Latest Ad:
1997 cub cadet 7275 compact utility tractor 4wd hydro trans cracked block 3500
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
