Farmall & IHC Tractors Discussion Board |
Re: PTO Leaks
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Phil Auten on April 11, 2000 at 05:13:25 from (206.175.72.226):
In Reply to: PTO Leaks posted by mk on April 10, 2000 at 16:03:53:
Ditto Tom's experience with the PTO seal on my M. Got the seal from the local Case/IH dealer for under $15 (there are two of them on the M since the original was a double seal). Just work carefully and the PTO seal will be pretty obvious as to how to replace it. The belt pulley seal may be a little more involved, but should also not be difficult. If you're worried about the job, get a manual first. Even an I&T manual will help, but I recommend that you get a reprint of the factory manual, which is available from the folks here at YT. Look at the top of the gray bar on the left and click on Tractor Manuals. It'll be money well spent since you'll be needing it in the future for other things like this. My 2¢, Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|