Posted by Eric Bergstrom on May 28, 2009 at 21:58:24 from (24.118.249.169):
I have a '49 W-4 that I painted/restored a few years ago. The engine has always run smoothly and without smoke, so I never overhauled it.
I didn't have much opportunity to really plow with it until recently, and I've encountered a problem. Last year, after I had plowed for quite a while and the engine was good and hot, it started to pop and sputter and miss, and eventually it died. Then it wouldn't start until cool. So we adjusted the valves to what the manual suggested (.017?).
This year, it did the same thing again so my Dad adjusted the valves this time. Upon the third outing it started to act up just as we were finishing (we had less to plow this time).
Anybody know what's causing this? If it's the valves, what do you have yours set at?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
