Posted by charles todd on June 14, 2009 at 10:17:58 from (205.242.95.142):
In Reply to: wide or narrow on M posted by pheel on June 13, 2009 at 03:43:24:
I have a 62 Farmall 504 Diesel that I put a NEW Koyker loader on in 2007. With the loader, bucket, and hydraulics, I have spent about $4500 alone. I know the value of a 62 F504D is propably less than the loader alone. I also plan to buy a NEW Schwartz WFE to replace my Speeco WFE that is slap wore out. The reason is I can rebuild a POS for $5-600 or new for $1100 and be 2x as strong. I am also going to buy new rims and install 9.5L-15 tires.
The reason I do not mind putting $6000 into a paid for, older, solid tractor is I am not using it commercially and $6000 is just a down payment on a new equal. A 4x4 NH 60 HP with a loader, no shuttle, no remotes, bare bones tractor was $36,000. Nice, but I cannot justify that right now.
I am using this equipment to clear land (50 acres) and use my excavator to load stumps into the bucket and carry them to a pit for burning. I have uneven ground, holes, and ruts. It is HECK on the tractor, especially the WFE. The tie rods, spindle bushings, and pitman shafts are past their prime. NO WAY WOULD I USE A NARROW FRONT FOR LOADS LIKE THIS! There are times that the WFE has a hard time searching for stability. Although a NFE turns on a dime.
My Wife and Equipment Operator
Stump
More Stumps
I would have better pics, but I "misplaced" my camera and it got ran over, the root rake got it, and the disk cut into it. Looked like hammered cat $hit, but the battery and card were unharmed. Went on EBAY and found the exact camera and bought another!
Enjoy,
Charles
This post was edited by charles todd at 10:23:08 06/14/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
