Posted by JMOR on June 21, 2009 at 12:53:36 from (72.181.158.237):
In Reply to: super md gen question posted by Mark Peters on June 21, 2009 at 12:23:55:
Andrew Z said: (quoted from post at 15:23:55 06/21/09) im working on geting my super md's generator wired up i have followed the manual for the tractor and used bob m's diagrams to check over everything. however i seem to be having problems with it charging. when the engine is running i get 13volts at about 700 rpms yet when i increase the rpms it drops way off to 12 or less. finally when i stop to tractor it shows a strong discharge out. (kill switch in or out). i have tried john t's trouble shooting check list but have not really found any changes yet. the voltage reg is new and the gen is rebuilt.
thanks for the help
Andrew
You say that you have 13v @ 700rpm, then drops to 12v as increase rpm. What is ammeter showing at each of these two conditions as well as what is it doing as rpm are gradually increasing?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
