Posted by spiffy1 on July 10, 2009 at 06:56:31 from (70.41.135.42):
In Reply to: Tractor fuel. posted by teddy52food on July 08, 2009 at 19:52:59:
Thanks Bob!
Knowing that, I'm becomming more and more partial to the mid '29 to 1930 22-36s - the lower water elbow has a manual thermostat [not a great selling point against some of the competition so later ones were automatic, but sure fool-proof] and can have that manifold vaporizing tar on a pint of gas!
I warned him about the oil dilution, and recommended a full oil change before winter in addition to separating and topping off the oil the next morning. Actually, I've never heard or smelled a McCormick Deering on kero, so I'm probably as itchy to see it as my neighbor is.
For the price, I think #1 diesel will get me real close to [modern] kerosene and much cheaper around here [last I checked]. Probably start with at least 10% gas to give it some ocatane - I hate to pound the babbit out - 4 poured rods get's expensive, not to imagine pistons or valves [the latter can be found, but $40 each]!
You are correct, I want to use the water to cut the ping [though, believe or not, the operators manual claims it's best to leave just a bit, the brake power should let me know if I'm too far one way or the other], however, for that reason, want the fuel mix to be "pingy" enough to notice when the water is doing it's job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.