Posted by MeanGene1 on July 23, 2009 at 14:10:59 from (74.85.19.246):
In Reply to: Re: 656 vs 706 posted by Phil Munson NY on July 22, 2009 at 20:27:27:
My grandfather was an IH dealer when I was growing up in NY, and we ended up with the first "Demonstrater" 706D in '63, and later got a second one, probably a '64. A gent who owned a farm next to one of ours bought the "Demonstrater" 806D. At the local show/demonstration days, both whooped hard on the 3020 and 4020 Deeres in the plowing exhibition, the 806D pulled 6 bottoms in 3rd, and the 706D pulled 5 in 3rd without breathing hard- would pull 4 in 4th at 1800 with ease. Governors were at 2300. The "Demonstrater" 706D had loaded 18.4-34"s with 4 sets of weights, and was very well balanced with a full rack of front end weights- we started running two of the big 100# 'ers with the rest the regular 73# "ers on the front, and it worked out great. We had both until around '75, and never a serious problem with either. As was stated, the 656 was a dressed-up earlier, lighter tractor brought out as an "economy" version- the 706 shared the larger, heavier frame of the 806, and later the 1206, etc., making the driveline pretty indestructable at the 706 power level. Also had the dual-range trans, better brakes, steer it with one finger, etc.- better, more modern tractor all around. We had a pair of M's before that, so we had quite a run of trouble-free tractors between the four of them. BTW, a dairy farmer we partnered with on oats and hay would borrow one of the 706's to power his feed grinder, as his 3020 didn't have enough huevos to run it at more than half capacity- the 706 never slowed down
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
