Posted by TreeFarmer1414 on July 29, 2009 at 16:32:37 from (66.158.169.70):
Gentlemen: I sure could use some help in finding some parts for a Super A distillate tractor with mid-mount mower (#22, I think). My needs are: 1. shutter control rod. I need everything from the shutter to the quadrant control by the driver's seat. 2. touch control stop. I have three good ones but need a fourth. 3. Stay rod nut for the mower. This is the funky looking nut that holds the cutter bar vertical for transport. 4. I don't know the correct name for it but I need the piece that attaches the chain to the rockshaft arm to raise the bar. and finally 5. a divider board that looks fairly original. This may be the hardest to find. The one I have does not fit into the square notches. It has 3 rods while the parts book for a #22 Mower shows the divider board has 2 rods. A vendor at Red Power Roundup said he had the parts at home but now when I contact him by phone he doesn't have them. Any help/leads will be greatly appreciated. Also anyone know where to find a 140?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.