old tired said: (quoted from post at 18:55:19 08/05/09) I agree with spiffy one and look hard for the hood and side curtains.Glad you have good fenders. The e4a mag was what they come with from the factory. Look underneath it about where the bell housing comonly is it will have the casting date on it.Mine was cast on 2-15-1929.spiffy one glad to here yours is runing fine hope mine might in another couple of months.mabey I will find a hood someday.
Great to here yours is coming along! No doubt you'll have it purring soon!
I've seen a couple parts tractors in the past few months, even fanagled a pretty good set of fenders, but I can't help you on the hood. Actually, I may see a fellow, with a couple parts tractors, at the threshing show this weekend - I don't recall him having a hood, but is worth asking anyway. Now that I noted that, if I do see him, I'll probably forget - but not intentionally!
That reminds me, PaceF20: the engine block cast date hides behind the cold [GAS] setting loop on the original manifold, should be rather easy to find with an aftermarket. Of course, your serial number still put's it right in the middle of the '29s [roughly 30K starting at roughly 99,000] anyway.
This post was edited by spiffy1 at 20:46:41 08/05/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
