Posted by glennster on August 07, 2009 at 18:32:14 from (24.14.63.246):
In Reply to: W6 axle seals posted by JOE-ILLINOIS on August 07, 2009 at 13:06:07:
joe, i have the i-h parts books for the w and o series 6's tc-33d and also for the super w-6 's tc-47 (also for the w-4 and w-9 series too) so here is what i found. on the w-6 seriesthere is a felt washer pn 51982d for serieal numbers 501-2926, for 2927 and up it uses felt seal number 60630d. then there is an oil seal pn 51983d for serial numbers 501-2926 and pn 60624d for serial numbers 2927 and up. there is also a rear axle carrier cap gasket pn 56320d for all serial numbers and a rear axle sealing ring pn 60631d for serial numbers 2927 and up. it also appears to have came as an assembly rear axle carrier cap with felt washer pn 8191 dx for serial 's 501 to 2926 and pn 9095dx for serials 2927 and up. looking in the book for the super 6's, they ran the later seals that the w-6 2927 ser on up ran. let me know if you need any other lookups, i have the manuals at home.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
