Posted by Harvesterguy on August 26, 2009 at 18:14:01 from (75.196.113.249):
I ordered a used glow plug meter for my 656 and when it arrived the tag stated it was from a 444. I asked the dealer if in fact 4 cylinder meters were interchangeable with the meter from 6 cylinder models. He stated they were the same.
I can"t get my head wrapped around the fact that a 6 cyl. should have 50% more amp draw than the 4 cyl. therefore the 6 cyl meter should be heavier. I tested the 444 meter on the 656 and it instantly goes to full pegged when the glow plugs are on. Should it? How would it register that 1-2 plugs weren"t working if it was designed for 4 cyl?
The Part # from the 444 meter is 378352R91. I don"t have the 656 meter therefore no part number to cross check. Any advice would be greatly appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
