Posted by Red Mist on September 06, 2009 at 18:37:00 from (67.142.130.11):
In Reply to: SH Clutch adjustment posted by Deano4863 on September 06, 2009 at 17:47:18:
Deano4863 said: (quoted from post at 17:47:18 09/06/09) Hi Guys,
I'm working on a super H with the Rockford clutch. This clutch has a bolt on each of the 3 arms that comes into contact with the throw out bearing. What is the adjustment on those supposed to look like? I have the external linkage adjusted to 1 1/8" from the platform. Thanks in advance.
If your free travel is 1-1/8" off the edge of the deck and the clutch is engaging smoothly, then don't worry about it. Unless you are riding the clutch a lot, or constantly starting off in 5th with a load hooked to the tractor, it will probably last you another 10 years easy....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
