Posted by aeronutt on September 19, 2009 at 19:03:28 from (68.229.162.121):
In Reply to: Is this an H manifold? posted by Mike CA on September 18, 2009 at 20:49:48:
Well, since my pretty painted manifold came off a distillate tractor (has the little fuel tank, but it's rusted clear through...), and the engine has the flat-top distillate pistons and distillate head I assumed the manifold would be distillate too. Apparently some folks that are more familiar with these parts know better. I bought another distillate M tractor yesterday, but I haven't lifted the hood to see what the manifold looks like. Since my manifold has been identified as a gas M manifold, here's a nice up-close of the casting number to help you further confirm the identity of your rusty one; I think the number is 8035DG, but I'm not sure about the last character. Mine measures 20.5 inches tip-to-tip.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
