Posted by D Slater on October 03, 2009 at 09:29:51 from (72.65.137.34):
In Reply to: clutch in m posted by sblair on October 03, 2009 at 08:37:02:
If the pto turns and would have power under load. Make sure the shifter and shift forks are actualy putting the gears in mesh. If so there's a broken main shaft near back or a shaft somewhere else on back. Bull pinion ,axle etc. Or ring and pinion striped, differential bad or bull gear and pinion striped. Most of them would make a noise or catch if tractor was rolled and I wouldn't bet on any one as the problem. You could remove brake covers or take adjusting bolt out on bottom of covers and stick a wire up to see if one side is turning and the other not to narrow it down. Don't know the climate your in. Have saw the shift forks rust until they wouldn't move on some that sit for years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
