Posted by ScottyHOMEy on October 03, 2009 at 15:50:23 from (64.222.246.201):
In Reply to: Serial # Plate posted by JeffnPA on October 03, 2009 at 10:07:11:
I don't know how they were made in the first place, but I've had good luck with two plates of the same era, by masking off the edges and taping over the flats where the numbers are stamped, painting them over with black lacquer and wet-sanding back down with 1600-2000 grit. When the raised lettering has re-appeared, I give it a kiss or two more with the 2000 where needed, then give the whole affair a couple of coats of clear spray lacquer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.