Re: SA Clutch adjustment

Posted by Dellbertt on October 27, 2009 at 16:40:13 from (209.172.23.90):

In Reply to: SA Clutch adjustment posted by Dellbertt on October 27, 2009 at 11:51:32:

I agree Scotty,

It has been on my mind why it stops and shifts so easily from a roll but not from a running neutrol. I have been thinking of a sticky throw out bearing.

I looked again thru the archives and found an excellant discussion with you, Mike and Hugh.

After reading that, I easily adjusted the pedal for a little less than an inch of pedal free travel. I am getting plenty of clutch travel that I should not be having grinding problems.

When I opened the port to grease the bushing I noticed a lot of dried dirt and grease.

I missed supper doing this so I am going to look at it again tomorrow pm.

I ran diesel fuel through the trans and actually it is pretty dang clean in there.

I found the inspection plate on the bottom of the bell.

He is the big question. What is the easiest way to free up the throw out bearing?

Dell

Replies:

• Re: SA Clutch adjustment ScottyHOMEy 18:45:34 10/27/09 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.   Advanced Posting Tools   Upload Photo  Select Gallery Photo  Attach Serial # List  Return to Post

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]