Mike - Early production light switches had a fuseholder on the backside of the switch. Later production use a separate fuseholder mounted in the ammeter panel cover.
I recommend a 20 amp fuse in the supply to the light switch. You can do this a couple ways:
1 - Get a cartridge fuse holder, drill a hole in the ammeter cover and mount it as in the later production tractors. (Try Radio Shack or the CIH dealer for the fuseholder.) Use an AGC20 glass fuse in the holder.
2 - Use a modern blade-type fuse and fuse holder and tuck it inside the ammeter box. (A blade fuse holder runs about $1 at any auto parts store.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
