Posted by glennster on November 04, 2009 at 17:29:42 from (24.14.63.246):
In Reply to: Farmall H Engine Gaskets posted by Brian Justin Meierkord on November 04, 2009 at 14:30:58:
pull the rocker shaft off the head and then take a look at the valve springs. they should all be about equal. if you are pulling the head, i would have the valves and guides checked at this time, may need a valve job. when replacing the head, back off the adjusters on the rocker arms before tightening the rocker shaft down. the set the valves. water pump pulle flange needs a good soaking in penetrating oil, (i use pb blaster) then work it loose. chech the archives on the water pump, there are lots of posts on that. if you are not sure and havent worked on one before, get a service manual, there is a lot of info in them. the i&t manual is pretty good. this site sells manuals up at the top left in the store.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Tractor Lovers Dream About - by Angus Crawford. The day started at five o'clock on the morning of Friday, the January 29, 1999. My father, my sister, my uncle, my cousin and myself all climbed into my uncle's Toyota van. It was six thirty in the morning and we had a long day ahead. We traveled for six and a half hours to our destination - a little country town with a population of no more then one hundred and fifty people (57 of them being children under the age of thirteen). We arrived hoping to meet up with a man we knew had over one
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
