Del, remove the gear from the shaft, should be one bolt or pin. A 7/8" headed 5/8" fine thread bolt holds the driving sleeve to the axle, remove it and the driving sleeve. 4 bolts - 3/8" course thread hold the seal retainer to the final drive housing, remove them and thus the retainer. There may be some oil there but it won't be much. You now have all the parts to give to the buyer. You will now need a spacer to replace the job that the sleeve was doing holding bearings in place and a cover to replace the seal retainer. If the buyer's tractor has no drive, it would be handy if he would provide you with his parts to replace yours. If not, don't be concerned, they are plentiful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
