Posted by Mike CA on December 05, 2009 at 19:47:32 from (99.28.152.102):
Tried to free the exhaust heat valve in my distillate manifold, but it was stuck beyond anything freeable. The guy working with me on it said he could re-manufacture the internals, so we decided to just cut it all out. Glad we did, because below the valve it's a mess of rust!
There were two freeze plugs on the side. Both had holes that were filled with carbon. So we got those out, and I've started cleaning down in there. I'm going to scrape as much scale as I can out of there, then I'm going to throw it back in the electrolysis tank so the solution can get into those exposed areas.
Does anyone know of any place that has new heat valves and handles? I'm going to start searching the usual places, but I've never seen them offered. If I can't find them, we're just going to make then from scratch. (This guy is really good!)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
