Posted by Slappy on December 12, 2009 at 18:37:05 from (68.221.185.67):
Of the 16 head studs on my Farmall M, 4 of them are 'long' (about 1/4 inch longer than the others). I took them out to have the block reworked and now it's time to put them back but I'm not certain where two of the four long studs go.
Two of them go under the governor control bellcrank bracket, but does anyone remember where the other two go?
My best guess, based on the drawing in the parts manual, is that the long studs all go in the same row. There are seven studs outside of the valve cover and it looks as though the long studs may go (from front to back) in positions 2, 3 and 5,6 (bell crank bracket).
Any information is most appreciated. Thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
