Posted by Wardner on December 15, 2009 at 20:20:26 from (4.154.245.208):
In Reply to: Re: hydraulics help posted by Nebraska Kirk on December 15, 2009 at 19:41:39:
Kirk,
The pulley uses a tapered bushing to secure it to the crankshaft. The hand crank stuff has to come out temporarily in order to slide it in there. A single groove pulley might be easier to install. It is the same diameter as the IH pulley. Clearance to the bottom of the fan shroud is 1/8".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
