Posted by bc on December 21, 2009 at 21:39:35 from (71.158.222.215):
In Reply to: Re: 656 engines posted by karl f on December 20, 2009 at 17:29:35:
Karl is right. I just had it in the back of my head it was a common one like the ph8a. The IH engine spin on filters are a 1" & 12 thread. The fram cross ref is PH 2842, PH6354, & PH6923. I just remember walking into to TSC and seeing a whole shelf of Fram filters that would work. Same for Walmart. Too bad I don't like fram anymore.
wixfilters.com has a good computer cross ref that you can put about any filter number in. Then you can bring up the specs including the filtration micron ratings. You can then go to O'reillys website who carry wix and it can tell you if your local store has it in stock or if they have to order it. That and/or a phone call saves a lot of driving.
One of the wix filters is shorter. You can look at the specs for all of them and decide which is better. Either I liked 51768 or that was the one in stock when I went there.
The IH numbers for hydraulic filters also cross ref with wix and oreillys carrys them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
