Posted by Andy Martin on December 22, 2009 at 12:24:35 from (199.197.2.143):
In Reply to: Re: 1948 MD posted by Adam Wiles on December 22, 2009 at 07:00:50:
If it is disassembled I'd offer $600 and settle for $700.
If you rebuild the engine you are easily talking $3,000 to $4,000 once you find the parts.
Two years ago it seems everything was $100 per hole:
Valves $35 each, four rings $25 each, piston $95, sleeve $110, head rebuild $400, head gasket $100. It adds up.
You are money ahead if you find one running well and haul it 1000 miles.
So it does not hurt to talk him down, but saving $400 up front does not pay for an engine rebuild.
I have several, including MD's, Super MTAD, and 450D. Still looking for SMD and 400D. Taken care of they are a blast to own and run. I never get tired of switching from gas to diesel and listening to it pick up on diesel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
