Posted by Nebraska Kirk on January 01, 2010 at 13:34:10 from (207.91.4.188):
In Reply to: For Nebraska Kirk posted by ScottyHOMEy on January 01, 2010 at 13:06:53:
I am sure the clutch would handle it fine, as long as it is adjusted correctly it will not slip even under very heavy load. I have a '47 M with a hand clutch and I have plowed a few times with it, even in very hard ground. I have powered out and spun out without any sign that the hand clutch was slipping.
The manual recommends not to do any heavy pulling. My personal opinion is that, as long as the clutch is in good shape and adjusted correctly, some occasional plowing will not hurt it. I would be hesitant to plow all day for days on end like what these tractors did originally. Keep in mind that heavy pulling puts extra stress on the M&W clutch parts, very few replacement parts are available new and a limited supply of used parts.
I do not have a manual specific to the Super H clutch, but I do have one for the Super M clutch, the information would be the same, just the part numbers in the parts diagram would be different. Send me and email or PM.
This post was edited by Nebraska Kirk at 13:36:44 01/01/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
