Lance_MF_180 said: (quoted from post at 06:18:24 01/14/10) Thanks Everyone! I will looking for the input gear from a Super M then if I am understanding correctly!?! This M goes on the blower during silo filling, light plowing with a 3-16 melroe pull type auto reset, and sometimes disking with a 13 foot disk after chopping just to level rows out. Major tillage is done with an IH 886 and a 6-16 melroe onland plow, but I love the sound of the M pulling hard anyday before that diesel 886!
I am fairly certain you are looking for the 4th/5th gear. The input and ring gear would make you go faster in all gears. If you wanted to go slightly faster in all gears you could put an I or W 6 ring gear and input in. If you find one have fun paying for it!!!
You can't pull a 13 foor disc with an M!?! You are so full of... Don't worry, it is coming. I have seen it all too many times. The people like to say you have to pull a 9 footer on this board. :shock:
I don't see my picture above, I will try again on this post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
