Posted by Zachary Hoyt on January 26, 2010 at 15:39:38 from (74.33.192.56):
I've taken the retainer off and took it with the leaking seals (there are two for some reason) to NAPA. They cross referenced the seal number, which also matched the number given on the CIH web site. The seals they sent me home with are 2.1" OD and the hole in the retainer, now that I got the seals out, is only 2-2.05". The ones I bought are 13602. Does anybody know if that is the correct number or if there is a different one I should ask for? There is a thin metal ring inside the cast retainer that looks like it would make leave a hole close to the right size if I removed it, but it looks like the flange on the thin metal is what holds the seals in. I am sorry not to have a picture to show this. My camera batteries don't charge well enough anymore, and I haven't figured out what brand to buy to replace them. I'm sorry this is so long. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
