Posted by Harold H on February 22, 2010 at 06:32:49 from (98.18.184.81):
In Reply to: 64 Model 806 Fenders posted by Bill47 Perry on February 20, 2010 at 21:08:26:
Fenders were optional on the Farmall 806 (and F706) all through it's production run. The International 806 (and I706) had the big full coverage fenders standard. Clam shell fenders were optional on the Farmall 806 (and F706). These were basicle the same as the 560 fenders but the mountings were different to fit the 806 axle housing. The optional flat top fenders for the F806 (and F706) were introduced at the same time as the Farmall 1206 tractor line was introduced. The flat top fenders on the 1206 were standard but could be deducted if the customer did not want fenders. Most tractors sold in the Delta at the time were sold without fenders.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
