Posted by karl f on February 25, 2010 at 21:01:19 from (172.163.14.236):
In Reply to: Farmhand loader posted by EKP60 on February 25, 2010 at 14:18:15:
width is easy, you just find spacers one inch thick per side. length i cannot recall what it is between H and M, but most implements made for one were meant to be used on both by changing one or two mount points and spacing the frame. our mccormick loader has 2 different holes for the front braces that are only 1 or 2 inches difference depending on H or M.
If you found installation instructions you'll likely find the difference in mounting the two is right there in front of you, but is too simple to figure out. it's a rule related to murphy's law :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
