Posted by The Dukester on March 03, 2010 at 21:32:39 from (4.229.144.130):
In Reply to: Proper emblem for W6 posted by Gary fom Va on March 02, 2010 at 16:32:35:
A '45 W6 would have had the front cast brackets about 10 inches long with 2 holes in one end and the round "shaft like" mount perpendicular to the rest for the light clamp for the front lights..this bracket mounted on the front of the tractor on the front set of the holes in the front tub/frame beside each of the grill sides. The rear bracket was cast too, about 5 inches long with the one end curved to fit the lower fender area where it mounted with two bolts to the left rear lower fender/fender bracket and stuck out toward the rear with the rounder shaft-like part facing the rear to mount the tail light. Sorry I don't have a picture(s) but you might be able to scope one out on here somewhere.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
