Posted by GeneMO on March 04, 2010 at 20:48:57 from (216.74.193.175):
In Reply to: Farmall M loader's posted by 3500sport on March 04, 2010 at 20:17:33:
I think the IH model# was the 33. I had a trip bucket, so basically all you could do was lift something straight up. Then dump. Ours had a manure fork with 7 or 8 flat prongs. Then there was a dirt bucket that fit over the prongs.
They were a pretty rugged loader. Kinda heavy on a tricycle front end and you had to be extrememly careful to not load it too heavy, or drive with a load too high up in the air. As far as a stationary, straight up lift. I have seen my dad pick up white oak logs, 12 - 14' in length that were 18 or 20" in diameter on the little end.
Now you wanted to pick the log up and back a wagon underneath it. Didn't want to drive around with that kinda load or you would end up upside down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
