Posted by neblinc on March 10, 2010 at 13:19:01 from (71.31.211.19):
In Reply to: Tool advice posted by MNC on March 06, 2010 at 17:56:43:
When I started my Farmall H hobby I just had a basic set of mechanics tools. Ended up buying a craftsman tool set on sale at Sears that has most everything I need except for the large sizes.
Stuff I added over the years, Gearwrench sets, very handy. Punches, prybars, air tools, gasket scrapers (the long handled one with razer blade is the best).
The following was all purchased at Harbor Freight (Hate buying Chinese stuff if I can help it, but for a hobby saving money was key for me).
Engine stand, engine hoist, jack stands, tool chest, hydraulic press, hydraulic jacks, 3/4 socket set, large set of open end wrenches, seal pullers, 3 jaw pullers, brass punches, dead blow hammers and more that I can't think of ; )
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
