Posted by John T on May 25, 2010 at 04:32:06 from (66.244.97.31):
In Reply to: Plug Wires posted by Garry in Tenn on May 24, 2010 at 18:59:49:
Yep, Ideally they shouldnt contact each other a whole lot and I like to use looms or seperators and holders etc so they are kept away from each other, the block or metallic components. Their insulation should have plenty sufficient voltage withstand ratings that they can touch metal or each other, but keeping them away from each other or metal is to AVOID TEMPTATION LOL. In addition to a voltage breakdown arc theres that whole thing of mutual inductance and capacitance (crosss talk) which is just yet another good reason to avoid them being in close contact and/or looping or long close paralell runs together regardless if its minimal, its just how I prefer to route them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
