Hi Ken, I got my C279 black land planter up and working and I too am getting my cultivators hooked up. I planted on 38" rows and have my wheels set at 76" on center. I set up 2-8' 2x4's on the ground 38" apart to simulate the rows. After that it was pretty self explanitory to me what has to be loosened and moved. Between the 2x4's and a tape measure I got it looking good and symetrical. I have the C254 cultivators with the #10 tool bars,full shields and the C-53-C fertilizer units. I have ordered new drive chains and then they will be operational. I got lucky and got the C-254 owners manual with the tractor. On the front frames I created alot of extra work for myself by not getting the tool bars close 1st and then moving the shanks. There's a tip there:) Also leave enough adjustment so that you can be very close to the plants when they are small and be able to move the shanks out as the plants grow and the root sytem expands. The back mounted cultivators were already set up for 38" rows on mine. I ended up with alot of extra planter and cultivator parts if you need anything. I also have the front mounted skip row middlebusters that I'm not going to keep. I have a fast hitch on mine and have a set of 3 bottom FH middlebusters.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
