Posted by oldnnew on June 11, 2010 at 06:08:55 from (208.125.67.57):
Alvin Dick said: (quoted from post at 19:27:45 06/08/10) I have splined PTO shaft I would be willing to sell, It is the small diameter on the out side with and adapter for the standard size on it. I would sell it for $45.00 plus shipping or you pick it up.
Just to confirm, I can simply remove the newer style PTO assembly that I installed years ago with the splined countershaft, and just slide in the old style smaller PTO assembly? There are no issues with the countershaft in the trans matching up with the old style splined shaft? Does this shaft that you have, have the mounting flange? If not, that's ok since I still have the original one from my '40 H.
Where are you located?
This post was edited by oldnnew at 06:15:24 06/11/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
