Posted by Farmallb on July 10, 2010 at 13:37:17 from (12.74.222.83):
I bought a pulley rod from a man as my 48 H didnt come with one. There are 4 holes, not counting the mounting hole that it might fit in. 3 not counting the hole the choke rod goes into. I have tried it in each of the 3 and it does not work. There are 2 holes in the arm holding the hydraulic rod, but it does not work in these either. My dad had a 48, and im prone to believe that the lever attached to the top of the pulley housing had an angle or maybe 2 to it. Mine has none. just a slight riseing in a straight line from inside out, and maybe only a 1/4 to 1/2 in from inside to outside. Also, it seems longer than dads, sticking out maybe 3 / 4in out onto the front of the steering post. Where do I stick it lol
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Kreem Brand Fuel Tank Liner - by Staff. This condition has occurred on a few machines that we have had and fortunately we were able to borrow the technique used at the local motorcycle shop. The product that we have used is called Kreem thouh there are others on the market, this one was recommended and available. This particular product is sold in three parts, a bottle of etch, dryer, and sealer. We were fortunate enough to start the process with stern warnings from those that had used this type of product before. The horror
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
