Posted by lbg57 on July 11, 2010 at 17:35:19 from (99.149.113.250):
Sorry to keep pestering everybody with questions but here are a few more. I just want to do this right the first time.
1) On my Starting Valve Shaft (256 102 R93) that is on the rocker arm assembly, the duck bill lever on it that acuates the whole shaft was broken and a not so good job welding it back together. On 2 others I have looked at, it was welded up on those also. Is this common with these? Should I grind mine down and get it welded up better or is their by some chance one out their somewhere that is not broken?
2) This MD did not have any type of upper radiator support on it. The parts book says I need a Radiator Tie Rod (69 230 D) not the "U" shaped radiator brace (52 707 DB). Where does this tie rod attach to on each end? I looked in the owners & service manuals but cannot find any pictures of where it goes.
3) Is their any place to get copper or brass Per Cup Gaskets? The only ones I can get from I-H are made of steel and don't seem to seal very well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
