|
Farmall & IHC Tractors Discussion Board |
Dumb tractor hauling question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on June 05, 2000 at 12:59:20 from (206.5.110.15):
I'm too chicken to haul my new Super H and am hiring it done. Here's the dumb question...If I have it hauled on an automotive type rollback wrecker, should I have it winched up front first or back first? It is a wide front...if it goes on front first, I'm worried about damage to the front end while loading, but I would rather have it facing front first so the rear end can be chained to the back of the wrecker. If it goes on rear end first there is little possibility of damage to the tractor, but then the front end of the tractor will be chained to the back end of the wrecker and I am concerned about damage to the front end during stopping. My guess is that it would be best to go on rear first, but want advice. What to do?
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
